Kessler MOTION CONTROL: Oracle Controller Full (3.02 SL) - Manual (Page 33)

SLIDER/DOLLY TIME LAPSE
MOTION CONTROL - SIMPLE
Before running your first time lapse on a slider or dolly, perform the
calibration procedure to insure proper function.
1: Once in Slider/TT mode press the MENU button until you
get to the main menu
2. Select Motion Control by moving the joystick up or
down
Press the MIDDLE JOYSTICK BUTTON or ENTER to confirm.
3. To toggle Simple mode, move the Joystick down to Advanced
Press and hold the 1 Button for 5 seconds
Press the MIDDLE JOYSTICK BUTTON or ENTER to confirm.
4. Select one of the following:
Continuous or No Intervlmtr
Press the MIDDLE JOYSTICK BUTTON or ENTER to confirm.
5. Press the 1 BUTTON to select 1:Distance
Camera
Motion Control < v
Advanced ^
Simple <
Continuous
No Intervlmtr
6. Move the joystick up and down to change the Y:Distance
amount. Distance is displayed in both inches and centimeters.
7. Once you have your desired distance adjusted press MIDDLE
JOYSTICK BUTTON or ENTER to save.
This will bring up the next menu for setting time.
Note:
You can move the joystick LEFT/RIGHT to navigate through sub-menus
8. Move the joystick up and down to select Y:Time.
Time can be adjusted in decimal minutes (M),
decimal hours (H), or decimal days (D).
9. Once you have your desired time set press the MIDDLE
JOYSTICK BUTTON or ENTER
10. Press ENTER again
1:Distance 3:Cal
2:Time ENTER:Run
Y:Distance
2.8IN 7.1CM
Y:Time 6M 47S
Pictures 280
1:Distance 3:Cal
2:Time ENTER:Run
33