Kessler MOTION CONTROL: Oracle Controller Full (3.02 SL) - Manual (Page 31)

SLIDER/DOLLY TIME LAPSE CALIBRATION
MOTION CONTROL - SIMPLE
Note:
Simple mode is a feature from the older versions of the Oracle.
The new SmartLapse™ mode superceeds it in everyway and is the
preferred method. Although if you are used to using Simple mode you
can still activate it by following these instructions.
*The Kessler Turntable will NOT work in Simple Mode*
1: Once in Slider/TT mode press the MENU button until you
get to the main menu
2. Select Motion Control by moving the joystick
UP/DOWN
Press the MIDDLE JOYSTICK BUTTON or ENTER to confirm
3. To toggle Simple mode, move the Joystick down to Advanced
Press and hold the 1 Button for 5 seconds
Press the MIDDLE JOYSTICK BUTTON or ENTER to confirm.
Before running your first time lapse on a slider or dolly, perform
the calibration procedure to insure proper function.
4. Select one of the following:
Continuous or No Intervlmtr
Press the MIDDLE JOYSTICK BUTTON or ENTER to confirm.
Camera
Motion Control < v
Advanced ^
Simple <
Continuous
No Intervlmtr
NOTE:
See page 17 for descriptions of Continuous & Intervlmter
(Intervalometer)
5. Select the desired Exposure Time
6. Select the desired Shutter Delay
7. Press the 3 Button to select Cal (Calibration).
9. Make sure the slider motor is positioned to your left and move
the carriage to the left side (closest to the motor) of the track
using the joystick.
This procedure requires measuring the distance the slider moves
from start point to end point. The easiest way to do this is to move the
carriage all the way to the end of the track (point A), run the calibration,
then measure the gap between point A and point B when complete.
1:Distance 3:Cal
2:Time ENTER:Run
31
Shutter Delay
1.00 S
Exposure Time
1.00 S