Sindoh D202 - Manual (Page 64)

Initial Settings of This Machine
4
-2
1. Preparation for network connection
(for administrators)
Checking a LAN cable for connection
Check that a LAN cable connected to the network is connected to the LAN port of this machine.
For details on the cable connection port, refer to page
2-9 .
Assigning an IP address
If this machine has a fixed IP address, manually enter the IP address, subnet mask, and default gateway address.
To configure the following settings, select Utility - [Admin Settings] - [ETHERNET] - [TCP/IP] - [IPv4 Settings]
on the Control Panel.
Settings Description
[IP ADDESS] When manually specifying the IP address, enter the fixed IP address
assigned to the machine.
[SUBNET MASK] When manually specifying the IP address, enter the subnet mask.
[DEFAULT
GATEWAY] When manually specifying the IP address, enter the default gateway.
[IP Appl Method] When automatically specifying the IP address, select the method for
automatic retrieval.
- [DHCP] : [ON] is specified by default.
- [BOOTP] : [OFF] is specified by default.
- [ARP/PING] : [OFF] is specified by default.
- [AUTO IP Settings] : Fixed to [Enable].
Note
- If this machine’s IP address is changed and the network settings are completed, this machine restarts.
- To check the IP address assigned to this machine, print out the Configuration Page.
To print out the Configuration Page, select [REPORT/STATUS] - [REPORT] - [Configuration Page]
from the main screen of each mode.