Restoring to factory setting, Restoring to factory settings -5, Printing system report page – Sindoh A610dn User Manual
Page 49
Using the Printer
3-
5
Restoring to Factory Setting
To reset the current setting to the factory default setting, select the factory setting menu from the general
setting menu, and follow the steps described below.
Follow the following instructions to restore to the initial factory setting:
1
Check if the [Ready] message is displayed with the printer power turned on.
2
Press 【◀】 or 【▶】 button until [Setting] appears, and then press the 【OK】 button.
3
Press 【◀】 or 【▶】 button until [General Setting] appears, and then press the 【OK】 button.
4
Press 【OK】 button after pressing the 【◀】 or 【▶】 button until [Factory Default] is displayed.
The message [Are you sure?] will be shown on the LCD display.
5
The basic settings will appear as No. Press the 【◀】 or 【▶】 button to change status to Yes,
and click on the【OK】 button.
Rebooting will be conducted after [Reinitialize] status, [Ready] will be displayed.
Note that all settings will be restored to factory setting.
Printing System Report Page
The system report page shows the current setting (the user-defined setting) such as the menu, currently
installed option, usable printer memory, etc. You can check the printer setting through this page. Should
you need assistance regarding the LCD display window and buttons, see
Using the Control Panel」 p. 3-2
1
Turn on the printer and have the [Ready] message displayed in the LCD display window.
2
Press
【◀】
or 【▶】 button to display [Reports]. Press 【OK】 button.
3
Press
【◀】 or 【▶】 button to display [System Report] message is displayed.
Press 【OK】 button.
[System Report Printing] appears while the report is being printed.
When the report is printed, the printer is switched to [Ready].
If another message is displayed while the page is being printed,
refer to