Clarion MAX973HD - Manual (Page 183)

87
MAX973HD
English
IN
ST
AL
LAT
ION
AND
WIR
E
CONNE
CT
ION MA
NUAL
Wire Connection
Note:
• For the optional devices, use the RCA pin cable and other connector cables sold separately.
WARNING
• Disconnect the negative terminal of the battery before connecting wires, otherwise an
electric shock, injury by short circuit may occur.
• Be sure to read the section "Wire Connection Notes" before installation or connection
operations.
Microphone
for voice
control
iPod
connector
cable
Speed sensor lead
Connect to the EC (Engine Control Computer)
vehicle speed signal line.
Parking brake signal lead
Connect to the parking brake signal line.
Reverse gear signal lead
Connect to the + terminal for the reverse gear
lamp that is only fed when the transmission is
put in reverse.
Vehicle signal lead
GPS antenna
CeNET terminal
IR remote controller sensor
RCA pin
lead
Refer to the following figure.
Audio
input for
AUX
Video output for rear monitor
Video input for TV tuner/AUX
Audio output for rear monitor
TV tuner
VTR etc.
Rear
monitor
CCD camera terminal
RDS-TMC antenna terminal
or
Power supply
lead
Pink
Grass-green
Purple/White
CeNET cable