Sound Devices PIX 220i - Manual (Page 68)

Connector Pin Assignments
Connector Pin Assignments Notes
XLR-F
(Analog inputs)
1–ground
2–signal (+)
3–signal (-)
Mates with XLR-Male connector
7.5k ohm input impedance, mic level
20k ohm input impedance, line level, active-
balanced
XLR-F
(AES inputs)
1–ground
2–signal (+)
3–signal (-)
Mates with XLR-Male connector
Transformer balanced
AES3 specification
XLR-M 5-pin
(Analog outputs)
1– Ground
2– Channel 1 Positive (+)
3– Channel 1 Negative (-)
4– Channel 2 Positive (+)
5– Channel 2 Negative (-)
Mates with XLR-Female 5-pin connector
120 ohm output impedance, active balanced
3.5mm TRS
(Headphone output)
Tip–signal L
Ring–signal R
Sleeve–signal ground
Mates with 3.5 mm TRS jack.
BNC
(Timecode output)
Center pin–signal
Sleeve–ground
Mates with BNC male connector
Unbalanced, coaxial connection
BNC
(SDI input & SDI output)
Mates with BNC male connector
Unbalanced, coaxial connection, 75 ohm con-
nectors recommended
BNC
(Genlock or Wordclock
output)
Mates with BNC male connector
Unbalanced, coaxial connection, 75 ohm con-
nectors recommended
5-pin LEMO
Timecode I/O
1–ground
2–SMPTE TC In
3–ASCII in/out
4–tuning out
5–SMPTE TC out
Mates with male LEMO B-series connector
Pin assignments as viewed on panel-mounted
connector
2.5mm TRS
LANC Tip–switch closure
Ring-LED driver
Shield–ground
Mates with 2.5 mm male connector
2.5mm TRS
GPIO
Mates with 2.5 mm male connector
eSATAp Female Mates with eSATAp male connector
Accessible only when PIX-CADDY is not
inserted
USB-A
Keyboard Input
For use with USB Keyboards only. Data trans-
fer is not supported
Hirose 4-pin
DC Input
1 – ground
2 – ground
3 – DC (+) *
4 – DC (+)
10-17 Volt DC input. *Pin 3 operates battery
charger for Li-Ion batteries. Mates with Sound
Devices XL-NPH and XL-WPH3 powering ac-
cessories. See Accessories for details.
PIX 220i and PIX 240i Video Recorder User Guide
66
v. 3.52 Features and specifications are subject to change. Visit www.sounddevices.com for the latest documentation.
Connect
or Pin Assignments