Sound Devices 633 - Manual (Page 33)

L, R, and ISO track routings to X3 and X4 can be set to pre- or post-fader. This setting is independent
of the values set in Setup Menu option INPUTS > Input to ISO Routing. The All ISO Tracks option on
this routing screen globally applies pre- or post-fade status to all ISO track routings to X3 and X4.
The Headphone Source in the X3, X4 Routing Screen is a special source which is a copy of the active
Headphone Source. Changing the Headphone Source will change the Headphone L and Headphone
R sources routed to X3 and/or X4 ( See “Headphone Source Selection”, page 22 ). This feature is useful
for sending a copy of the monitor signal to a boom operator or other production members.
RTN signal can not be routed to X3 and X4 buses. When Headphone signal is routed to X3 or X4 and
RTN signal is routed to the headphone preset, RTN signal will be present in the headphone output but
not in X3 or X4.
AES3 Digital Outputs (XLR-3M)
There is a total of 4 available channels of digital output on 2 connections. Each of the XLR-
3M outputs can be configured to output AES3 digital signals from the Setup Menu options
OUTPUTS > XLR-R Out and OUTPUTS > XLR-L Out.
Any track can be routed to any AES output in any combination. ISO Tracks are routed to
AES outputs pre- or post-fader depending on the Input’s setting in Setup Menu section
INPUTS > Input to ISO Routing.
Signal is routed to the AES outputs from the AES Output Routing Screen ( See “Routing
Screens”, page 13 ). The AES Output Routing Screen is accessed from Setup Menu option
OUTPUTS > AES Output Routing.
Output Se
tup and Contr
ol
633 User Guide and Technical Information
27