Casio AP-500 - Manual (Page 44)

E-40
Assembling the Stand
PREPARATION
• Before starting assembly, check to make sure that you
have all the parts shown below. You can find the screws
in a plastic bag inside of the polystyrene foam packing
material.
• This stand does not include any of the tools required for
assembly. It is up to you to prepare a large Philips head
(+) screwdriver for assembly.
IMPORTANT!
• If anything is missing or damaged, contact your local
CASIO service provider.
• Note that use of any unauthorized parts or components
can cause damage to the stand and/or the digital piano.
z Before starting stand assembly, unfasten the band 1
that bundles the pedal cable in the back of crosspiece
D , and extend the cable.
CAUTION
• This stand should be assembled by two people working
together.
• This stand should be assembled on a flat surface.
• Do not remove the tape securing the keyboard cover in
place until assembly is complete. Removing the tape can
cause the keyboard cover to open and close during
assembly, creating the risk of personal injury to your
hands and fingers.
• Take care that you do not pinch your fingers between
parts when assembling them.
1. Attach side panels A and B to crosspiece D.
Secure the side panels using four E screws.
• When installing part 2, slide the brackets 3 into the
slots in either end crosspiece D. If the brackets 3 are
not inserted into the ends of the crosspiece D as far as
they will go, the E screws will not be able to enter
into the screw holes of the brackets 3, which can strip
the threads of the screws.
• Cover the screw heads with the caps L.
2.
Slide back panel C into the grooves of the
side panels (
 ).
Unpacking
A
B
C
D
Part Size (mm) Qty
E 6 × 20 4
F 3.5 × 16 6
G — 1
H 6 × 14 2
I 4 × 16 2
J — 1
K 6 × 20 1
L — 4
1
To assemble the stand
3
2
A E
E
D
E
B
L
L
L
C
AP500_e.book 40 ページ ２００６年１０月１９日 木曜日 午後３時５４分