CITIZEN CL-S700R - Manual (Page 37)

37
Printer Operation
Menu Setup Mode
If the MENU key is pressed while the printer is in the On Line Ready state,
the printer enters menu setup mode. In this mode, the printer's configuration
can be changed using the operation panel. During menu setting mode, the
LCD indicates the current menu settings and the key function.
POWER ERROR
FEED
STOP
MENU
PAUSE
On Line
Ready
POWER ERROR
FEED
STOP
MENU
PAUSE
Main Menu
Page Setup
Exit Enter
Exit
Shift/Change
Shift/Change
Enter/Save
Caution
Functions of the keys
When you enter Menu Setup Mode, the LCD displays “Main Menu” on the
top line and Page Setup below.
In the menu setup mode, the four keys become “cursor keys” to navigate the
menu. Refer to the four small arrows in the centre of the keypad rather than
the names of the keys.
FEED key (Shift/Change)
The
5 key (Feed key) goes up the menu system or selects a higher
value
MENU key (Shift/Change)
The
∞ key (Menu key) goes down the menu system or selects a lower
value
STOP key (Enter/Save)
The
3 key (Stop key) selects or saves the item or enters a menu
PAUSE key (Exit)
The
2 key (Pause key) exits the current item (goes back) and eventually
exits the menu system
The menu settings are stored temporarily in the printer’s memory. They are
only permanently stored in the printer setup when you exit the menu system
and say “Yes” to the “Save Settings” question.
Mode Settings
Turning the power off while the printer is performing the “Save
Settings” function could cause a mis-save. Do not do this! If the
power is accidentally turned off, first reset the printer to factory
defaults.