CITIZEN CL-S700R - Manual (Page 58)

3
Printer Adjustments
58
Media Width Adjustment
The printer is already factory-set to the value of media width: 112 mm (4.4
in). When you use narrow media, adjust the printhead pressure in the
following:
1. Looking in at the check window on the upper frame, align the
mark (the left end of white plastic) with the width of media by
turning the media width adjustment knob. (The printhead must
be closed.)
2. Make fine adjustments by checking the self-test print.
When the print on right side is too light:
Move the mark (white) to the right side by turning the media
width adjustment knob clockwise.
When the print on the left side is too light:
Move the mark to the left side by turning the media width
adjustment knob counterclockwise.
Installing the Media
(p.25, p27)
Self Print Mode (p.36)
Media width adjustment knob Media width check window
Check window Width of media
25.4 mm
50.8 mm
76.2 mm
101.6 mm
1 in
2 in
3 in
4 in
When ribbon wrinkles or media
screws with media width of 4
in or more
Factory setting