CITIZEN CL-S700R - Manual (Page 59)

59
Printer Adjustments
Adjusting the Ribbon
Ribbon tension in this printer is already adjusted for the recommended ink
ribbon and media and is very tolerant to different types of media. However, it
may slip due to imperfect combinations of ribbon and media and it is possible
that you will see a “Ribbon End” message even though the ribbon is not
finished. This is more likely to happen with narrow width ribbons, especially
those less than 50mm (2 inches).
To resolve this problem and obtain the optimum printing condition, make
adjustments in the following manner (this should be done after the printhead
pressure adjustments on the previous page are made):
Adjusting Places
Adjusting Method
1. General ribbon and media
Factory setting: both marks on winding and feeding sections
are set to STANDARD so as to obtain the optimum printing
condition for the recommended ink ribbon and media.
Setting the Ribbon (p.32)
adjust-screw adjust-screw
Winding section Feeding section
When turning adjust-screw, use a flat-tip screwdriver.
TENSION
STANDARD
LOW
TENSION
STANDARD
LOW
SUPER LOW
Feeding section
Winding section