Cumberland Stove Works MF3700 - Manual (Page 25)

INSTALLATION AND OPERATION MANUAL
Models MF3700, MF3800
Page 5 800-345-6007 CumberlandStoveWorks.com
Problem Display Status Possible causes Remedy
Stove Will Not Light
NORMAL READINg
Hopper is empty Add fuel to hopper
Plugged firepot Clean firepot. Clear all holes of
ash or debris.
Igniter slipped out of torque arm Push igniter back into place
Igniter failed Test igniter output leads on IM.
Confirm air pump operation.
Replace igniter if needed.
No power to igniter Replace IM
NO PROOF OF FIRE
PUSH “ON” TO START Igniter failed Test igniter output leads on IM.
Confirm air pump operation.
Replace igniter if needed.
Pot Loading
NORMAL READINg
Plugged firepot Clean firepot. Clear all holes of
ash or debris.
Poor quality fuel Change fuel supplier/moisture
test corn
Firepot misaligned Make sure firepot is aligned
properly and that there is no
unburned pellets obstructing
proper alignment of firepot.
Problem Display Status Possible causes Remedy
Lazy Flame
NORMAL READINg
Poor quality fuel Change fuel supplier/moisture
test corn
Firepot and plate require cleaning Clean firepot and plate. Clear all
holes of ash or debris.
Firepot misaligned Make sure firepot is aligned
properly and that there is no
unburned pellets obstructing
proper alignment of firepot.
Fireplate in backwards Adjust fireplate for correct
positioning. Fireplate notches
should always face towards the
front door of the stove.
Smell of Smoke in Room NORMAL READINg
Exhaust vent is not sealed
properly Seal all joints of exhaust vent
with high-temperature silicone
sealant.