ClearOne Beamforming Microphone Array Installation Guide - Manual (Page 12)

9 Beamforming Microphone Array
Lift the assembly, along with the ceiling tile, into place in the drop-ceiling support framework.
Install the Support Rails in the ceiling over the ceiling tile and supported by the suspended
framework. Lower the Position Clamps into the Support Rail channels.
F 2X
Support Rails
Fully tighten the screws on the position clamps. Attach and tighten a Locking Plate on to each
Position Clamp to secure the assembly to the Support Rails.
G
HD
2X
2X
Locking Plate
Slide the Suspension Column up or down adjusting it so the Beamforming Microphone Array will
be placed approximately 8 feet above the floor.
2’ or 4’ Support
2’ Support
2’ Support
2’ or 4’ Support