ClearOne Beamforming Microphone Array Installation Guide User Manual
Page 22
19 Beamforming Microphone Array
Locate, level and mark for drill holes and the cable pass-through cut-out where the Wall Mounting
Plate will attach to the wall.
» NOTE: Wall mounting MUST be strictly horizontal to assure proper adaptive steering
of audio pickup.
Drill holes in the marked locations to receive the fasteners
Cut out the cable pass-through cut-out hole.
» NOTE: The anchors and screws used to mount the Wall Mounting Plate are not
provided and must be selected by the installer for the type of wall material supporting
the Wall Mounting Plate. Take care while drilling and installing the anchors so the wall
material does not tear out and weaken the attachment.
Attach the Wall Mounting Plate to the wall with fasteners.
If you have attached the Wall Mounting Plate to a hollow wall, thread the cables for Link In, Link Out
and PoE through the wall space and out through the hole in the center of the plate.
» NOTE: Allow enough extra cable length to pass through the hole to easily run under
the Mic Mounting Plate when it is attached to the microphone array and to the ends
where they are to be connected.
Wall fasteners not included
in the kit. Select fasteners
appropriate to wall material.