ClearOne Beamforming Microphone Array Installation Guide - Manual (Page 19)

Chapter 2: Ceiling Mount Installation 16
HE 3X
Cable Retention Clips
NOTE: ONLY INSERT
SCREWS PARTIALLY
Use #1 Phillips screwdriver bit
to avoid damaging screws.
Route the E-bus and PoE cables under the Mic Mounting Plate to the ends where they will be
connected, then Slide the Beamforming Microphone Array onto the Mic Mounting Plate with the
screws passing through the slotted keyholes.
Insert the final holding-screw through the Mic Mounting Plate into the Beamforming Microphone
Array. Tighten all screws. Plug in and route the cables through the cable slots and secure them
under the Cable Retention Clips provided with the Beamforming Microphone Array.
Slide Beamforming Microphone
Array UP & OVER Keyhole Slots
(E-bus and PoE Cables
Not Shown)
HE
Install fourth screw and tighten all screws.
Use #1 Phillips screwdriver bit to avoid damaging screws.