Install cylinder hoses, Mark cylinder hoses, Mark base end hoses – Great Plains YP925TD Assembly Instructions User Manual
Page 10: Mark rod end hoses, Remove frame caps, Route cylinder hoses
10
Flat Fold Marker
Great Plains Mfg., Inc.
113-870M
2012-22-03
Install Cylinder Hoses
Mark Cylinder Hoses
Mark Base End Hoses
35. Select the two base end (extend) hoses
,
.
See the table on page 6 for the correct part number
for the planter.
36. Mark one hose “R1” at each connector. This mark
does not need to be permanent. Masking tape
suffices. Mark the other base end hose “R2”.
Mark Rod End Hoses
37. Select the two rod end (retract) hoses
,
. See
the table on page 6 for the correct part number for
the planter.
38. Mark one hose “C1” at each connector. Mark the
other rod end hose “C2”.
Remove Frame Caps
Refer to Figure 11 (which depicts a lock nut; the actual
fastener set may include a plain nut and washer)
39. At each frame cap
, remove and save four sets of
5
⁄
8
-11 nuts
, any washers, and bolts
(part
numbers vary by planter model).
The fasteners are re-installed at step 71 on
page 14.
The frame cap
is not re-used.
Route Cylinder Hoses
Refer to Figure 12 (depicting a notional frame with top
entrance hole)
Cylinder hoses run inside the main or rear tool bar. They
enter the tool bar at machine center, via an entrance
hole
that may be on top of the tube, or on the front
face of the tube.
40. Route hoses
and
from the tool bar center
hole to the left end of the tube.
41. Route hoses
and
from the tool bar center
hole to the right end of the tube.
Figure 11
Remove Frame Cap
31802
11
3
4
R1
R2
C1
C2
11
4
11
Figure 12
Route Cylinder Hoses
32000
5
C1
C2
R1
R2
C1
R1
C2
R2
C1
R1
C2
R2