Great Plains YP925TD Assembly Instructions - Manual (Page 2)

2 Flat Fold Marker Front Appendix Great Plains Mfg., Inc.
113-870M Front Appendix 2012-22-03
Before You Start
Parts and Tools Required
• You need a suitable tractor for positioning the planter,
and having sufficient hydraulic circuits, with adequate
capacity to operate the markers (installing markers
increases the required circuits by one).
• You need a hoist with 136 kg (300 pound) capacity.
• Have safety goggles and gloves for inspecting
hydraulic connections and handling sharp marker
discs.
• Other than the hoist, only basic hand tools are
required.
• 5 liters (1.2 gallons) of hydraulic fluid is needed to
charge the marker system.
• General purpose grease lubricant and grease gun.
• Liquid PTFE pipe sealant, if the kit includes QD
couplers. See page 20 for more information.
Compatibility
Refer to Figure 2 (consult planter Operator manual for serial
number plate location)
1.
Check the model number of the planter against the
table at right to ensure you have the correct kit.
Sequence
If installing the markers as part of export pre-delivery,
perform the installation at the point called for in the
pre-delivery manual:
Comprehension
2. Review these instructions. Make sure the installers
understand where each part or assembly is
installed, and what tools are required for the task.
401-754Q YP625/925 Export Pre-Delivery Manual
Figure 2
YP925 Serial Number Plate
31980
Kit Compatible Planters
113-836A YP425A3P, spacings up to 30 in. (76 cm)
113-837A YP425A, spacings up to 30 in. (76 cm)
113-838A YP625A3P, spacings up to 30 in. (76 cm)
113-839A
YP625A, spacings 38 in. or 40 in.,
YP825A, spacings up to 30 in. (76 cm)
113-854A YP425A, spacings 38 in. or 40 in
113-855A YP425A3P, spacings 38 in. or 40 in
113-857A YP425A, spacing 36 in.
113-858A YP425A3P, spacing 36 in.
113-859A YP625A3P, spacing 36 in.
113-860A YP625A, spacing 36 in.
113-861A YP625TD, spacing 110 cm
113-862A YP625PD, spacing 110 cm
113-863A YP925TD, spacing 65 cm