Great Plains SS1700 Operator Manual - Manual (Page 19)

Great Plains Manufacturing, Inc. Table of Contents Index Preparation and Setup 15
06/14/2012 Table of Contents Index 596-086M
Straight Shins & Tips Assembly
Refer to Figure 8
22. Attach straight shin retainer
to the straight shank
with 1/2 x 2 1/2 bolts , 1/2 hardened washer and 1/
2 flange lock nut.
23. Slide one end of the straight wear shin under the
straight shin retainer . Hold the lower end in place by
installing a tip (1 1/4 x 2 with fin, shown) . Fasten with
1/2 x 2 1/2 bolts , 1/2 hardened washer and 1/2
flange lock nut.
Note: Install the 1/2 x 2 1/2 bolts as shown. The flow of
dirt on the underside of tip will tend to tighten nut.
No-Till Shins & Tips Assembly
Refer to Figure 9
24. Attach the retainer clip
to the no-till shank with 1/2
x 1 3/4 bolts and 1/2 flange lock nut.
25. Remove the 1/2 x 1 3/4 roll pin and save for later
use.
26. Slide one end of the no-till wear shin under the
retainer clip . Hold the lower end in place by installing
a no-till tip . Secure with 1/2 x 1 3/4 roll pin in rear
hole of tip (removed in previous step).
27. Insert the 3/4 x 1.7 heavy roll pin in front hole of tip
to help secure tip.
Coulter Assembly
Refer to Figure 10
28. Position the coulter stop
in the slot of the casting
assembly .
29. Slide the casting assembly and coulter stop onto shank
, sliding it up past the hole in the end.
30. Install roll pin in the hole and allow casting to slide
back down until it is resting on the roll pin.
31. Place jam nut on 5/8x1 1/2” set screw and insert
set screw in the casting assembly. Insert 5/8x1 set
screw
in the coulter stop and refer to See “Coulter
Alignment” on page 17 for proper setting.
5
1
4
Figure 8
Straight Shins & Tips
42786
3 6
3
2
4
1 2
3 4
5
1
6
3 4
3
3
Figure 9
No-Till Shins & Tips
42787
4
2
5
6 7
1
1 2
3
4
5
1
6 4
7
6
6
3
1
Figure 10
Coulters
42790
5
2
5
4
7
1
2
3
4
6 5
7