Great Plains SS1700 Operator Manual - Manual (Page 26)

596-086M Table of Contents Index 06/14/2012
22 SS1300 & SS1700 Table of Contents Index Great Plains Manufacturing, Inc.
Maintenance and Lubrication
Maintenance
55. Proper servicing and maintenance is the key to long
implement life. With careful and systematic inspection,
you can avoid costly maintenance, downtime and
repair.
56. Always turn off and remove the tractor key before mak-
ing any adjustments or performing any maintenance
Refer to Figure 17
57. After using the implement for several hours, check all
bolts to be sure they are tight.
58. After one hour and again after five hours re-torque the
Gr. 8 bolts and Gr. 8 clamp bolts to 400 FT LBS.
Re-torque periodically.
59. Lubricate areas listed under “Lubrication”, page 23.
60. Inflate tires as specified on “Tire Inflation Chart”, page
27.
61. Replace or rotate worn parts as needed -- hinge bolts,
clevis pins, bearings, etc.
62. Check and tighten or replace any hydraulic leaks. Check
hoses for any leaks. It is important that there are no
leaks on the equipment.
63. Grease wheel bearings and walking beams sparingly.
Over greasing may cause damage to seals and reduce
the life of the bearing. Grease hinge points periodically.
Storage
64. Store implement where children do not play. If possi-
ble, store the implement inside for longer life.
65. Remove any dirt and debris that can hold moisture
and cause corrosion.
66. Lubricate areas noted under “Lubrication”, page 23.
67. Inspect implement for worn or damaged parts. Make
repairs and service during the off season.
68. Use spray paint to cover scratches, chips and worn
areas on the implement to protect the metal.
By following and maintaining a routine service and lubri-
cation program, your tillage equipment will give you
many years of service.
For the most current manual information, visit Great
Plains website listed below. For more information on
operating, adjusting or maintaining your Great
Plains Discovator, assistance is available. Contact:
Product Support
Great Plains Mfg. Inc., Service Department
PO Box 5060
Salina, KS 67402-5060
(800)255-9215
Figure 17
Re-torque Bolts
42793
2 1
1 2