Great Plains SS1700 Operator Manual - Manual (Page 20)

16 SS1300 & SS1700 Table of Contents Index Great Plains Manufacturing, Inc.
596-086M Table of Contents Index 06/14/2012
Machine Adjustments
Pre-Leveling of Machine
Front to Rear Leveling
32. Pre-leveling of machine may be done on a level floor.
Lower the machine down until the shank tips are just
above the floor.
33. Adjust the 3 point top link until the front and rear points
are level.
Auto Reset Shank Adjustment
Refer to Figure 11
34. The dual spring package should be preloaded so both
top and bottom springs are loaded evenly and measure
23.8” from end of coil to end of coil.
Spring pack is pre-loaded at factory and should not be disassem-
bled in the field. You could be severely injured or killed by instant
release of stored energy.
Figure 11
Auto Reset Shanks
24464
Down Stop
(not visible)