Great Plains YP825A Operator Manual - Manual (Page 167)

2014-08-15 Table of Contents Index 401-651M
Great Plains Manufacturing, Inc. Table of Contents Index 163
Appendix C - Initial Setup
This Appendix covers setup tasks performed only once,
or at infrequent intervals. Routine setup tasks are
covered in “Preparation and Setup” on page 13.
Perform Appendix B tasks first. Some of these items may
already have been done by your Great Plains dealer:
a. Seed monitor console installation (below)
b. Frame-mounted row options
(see manual supplied with accessory)
c. Marker setup (Option, page 164)
d. High rate dribblers (Option, page 167)
e. Scrapers (Option, page 168)
f. Fertilizer drop lines (Option, page 169)
Seed Monitor Console Installation
Refer to Figure 148
The planter’s standard PM300 seed monitor system
includes a console
that needs to be mounted in the
cab of the tractor to be used with the planter.
Transport and Field Safety Risk:
Mount the module so it is easy to monitor during planting, but
does not interfere with safe operation of the tractor in the field
or on public roads.
The monitor includes cables for power , speed
sensor and sensor harness . Installation
instructions are found in the included DICKEY-john
®
manual.
Power color code is:
+ positive: red
- negative: black
The included bracket requires customer-supplied fasteners.
Post-Delivery Checklist
1. Read and understand “Important Safety
Information” on page 1.
2. Check that all working parts are moving freely, bolts
are tight, and cotter pins are spread.
3. Check that all grease fittings are in place and
lubricated. See “Lubrication” on page 110.
4. Check that all safety decals and reflectors are
correctly located and legible. Replace if damaged.
See “Safety Decals” on page 6.
5. Inflate tires to pressure recommended and tighten
wheel bolts as specified. See “Tire Inflation Chart”
on page 137.
Figure 148
PM300 Tractor Components
28138
1
3
4
2
5
1
2
3 4
5