ADS Environmental Services FlowShark HV QR 775005 A2 - Manual (Page 14)

14 ADS FlowShark HV O&M Manual
Connecting the Sensor to the Control Unit
Connect the sensor to the control unit by removing the protective cap from the
corresponding port on the unit and then inserting and screwing in the connector from
the sensor cable into the port.
When measurement is complete, unscrew and remove the sensor connector from the
control unit and replace the protective cap onto the port.
Operating the FlowShark HV
Turn on the FlowShark HV by pressing and holding down the Enter key ( ) on the
control unit for at least 5 seconds. The unit temporarily will display the current
firmware version installed and then the current temperature, peak velocity of the flow,
average peak velocity (when initiated manually), and time period over which the
average has been determined. This screen represents the first of three top-level
screens accessible through the control unit.
The second screen displays the battery voltage of the battery in the control unit and
indicates whether the sensor is connected to the control unit. The third screen
displays the signal quality of the measurment, the Doppler frequency, the main peak
velocity, the designated number of neighborhood peaks, and a histogram representing
the measurements taken. Navigate backward and forward among these top level
screens using the horizontal arrow keys (,).
Turn off the control unit by pressing and holding down the ESC key on the unit for at
least 2 seconds. The unit will turn off automatically following 8 minutes of inactivity
on the keyboard.
FlowShark HV display