ADS Environmental Services FlowShark HV QR 775005 A2 - Manual (Page 21)

ADS FlowShark HV O&M Manual 21
Maintenance
Perform routine maintenance on the FlowShark HV to maintain optimal performance
and maximize the life of the components. The maintenance interval and scope may
vary based on operational and environmental conditions and practical experience
obtained over time.
However, the following are some general maintenance procedures ADS recommends
implementing for the FlowShark HV:
 Clean the control unit and sensor after every measurement.
 Wash the sensor with warm water and mild dishwashing soap, and then
cleanse it using an appropriate disinfectant (when necessary).
 Clean the control unit with a damp cloth.
 Always store the control unit and probe/sensor in a safe location away from
direct heat or cold and, preferably, in a protective case when they not in use.
 Recharge the battery every 3 months when the FlowShark HV is not use. The
battery life will diminish in capacity over an extended amount of time in
storage.