Amico AHM Monitor Arms (Adjustable Height) - Manual (Page 7)

www.amico.com 4
Section 2: Installation on Rail System
Mounting to the Monitor Rail System (MRS)
with the MON-Adapter
WARNING: Never attempt to mount or remove the arm from
the rail when a monitor is installed.
WARNING: To prevent the adapter from falling down the
channel, ensure that the 4 set screws are fastened to the
tightest possible position
(Figure 1) .
NOTE: For safety, top and bottom stoppers prevent the adapter
from sliding out of the MRS. To remove, the adapter must be
taken out from the top of the rail with the top stopper pressed
back into the rail
(Figure 2) .
1. With the AHM arm locked in the highest vertical position,
support the bottom of the arm and guide the MON-channel
adapter into the top of the wall channel.
2. Once the arm is at the desired height, tighten all four screws
on the MON-channel adapter using a 1/8” (3 mm) hex key
(Figure 1).
OSHPD Anchor Pre-Approval OPA-1743
In compliance with standards established for the anchor and installation of instrument support systems by the
California Office of Statewide Health Planning and Development (OSHPD), Amico Accessories Inc. has obtained pre-
approval for MRS 19’’ Wall Channels or longer with extension Arm. For proper installation requirements please refer to
our OPA Document.
(Figure 2)
Top stopper
Bottom stopper
MRS Rail: Length for representational use only
(Figure 1)
Standard MON-Adapter
MRS Rail
Set Screws (3
mm)