Amico AHM Monitor Arms (Adjustable Height) - Manual (Page 8)

5 Amico Accessories
WARNING: To prevent the adapter from falling down the channel, ensure that the screws are secured to the tightest
possible position. After installation, rotate the AHM arm side to side and verify no movement is present between the
adapter and the rail.
WARNING: Removal of lock nuts will require a new set for reinstallation. Please contact Amico Accessories for spare
parts, 1-877-264-2697
1. With the AHM arm locked in the highest vertical position, support the bottom of the arm and guide the head of the
top screw into the opening of the rail (Figure 1) . Ensure the flange on the GTA is properly aligned with the rail. Slide
the GTA up so that the head of the bottom screw slides into the opening of the rail.
2. Position the arm to the desired height. Tighten the jam nuts and then the lock nuts on the top and bottom of the
adapter using a 12 mm wrench (Figure 2) . Cover the nuts with the plastic caps provided. (Figure 3)
Mounting to the Hill-Rom Rail (with the G-Track Adapter (GTA))
(Figure 3)
12 mm nut, lock
nut, and plastic cap
(Figure 2)
Opening of the rail
Jam nut, lock nut,
and plastic cap
GTA
Hill-Rom Rail
Front of the GTA
(Figure 1)
Head of the
bottom screw
Head of the
top screw
Flange
Backside of the GTA