Mounting of accessories – Amico Condor Adjustable Height Channel User Manual
Page 12
Mounting of accessories to the mounting channel can be done by mounting the accessories to an adapter first.
WARNING
To prevent the adapter from sliding down the channel, ensure the four set screws are fastened
to the tightest possible position, serious injuries could result if the set screws are not properly fastened.
NOTE:
Top and bottom stopper are there to prevent the adapter from sliding out of the MRS. The adapter must be
taken out from the top of the rail with the top stopper pressed back into the rail
1. Install the adapter onto the accessory to be installed. Before installation, please determine the approximate
position on the mounting channel that the accessory will be mounted. Remove both top and bottom Mounting
Channel covers (
Figure 4
)
2. If the accessory is to be mounted in the upper half of the mounting channel, then guide the MON Adapter into the
mounting channel from the top. For more detail, please see installation manual for accessory on how to mount to a
MRS Rail.
3. If the accessory is to be mounted in the lower half of the mounting channel, first remove the mounting channel
stoppers on the bottom of the mounting channel using a Phillips screwdriver (
Figure 5
). Then guide the MON
Adapter into the mounting channel from the bottom. For more detail, please see installation manual for accessory
on how to mount to a MRS Rail.
MOUNTING OF ACCESSORIES
Figure 4
Mounting
Channel
Mounting
Channel
Cover
12
Amico Accessories Inc.