Amico Condor Adjustable Height Channel - Manual (Page 9)

www.amico.com 9
Mounting on hollow wall:
1. Locate and mark the top mounting hole at a distance of 69"/168 cm from the floor for a configuration using single
SSM arms, and 71"/180 cm from the floor for a configuration using double SSM arms.
2. Use the Condor as a template to mark the remaining mounting holes, checking to ensure the Condor is kept plumb,
flush and level.
3. Drill ½ inch holes at each marked position.
4. Install snap-toggles in all 7 holes:
a. Hold snap-toggle metal channel flat alongside plastic straps and slide metal channel through hole.
b. Hold both ends of plastic straps; pull toward you until channel rests flush behind wall. Slide plastic cap along
straps with other hand until flange of cap is flush with wall.
c. “Snap” the straps to break away at the plastic cap.
4. Hang the Condor on the top screw and secure with ¼ -20 x 2 ½" (0.635 - 50.8 cm x 6.35 cm) flat head socket screw.
5. Secure remaining screws in holes.
General instruction for opening and closing the Condor covers (Refer to Figure 3)
The slotted edge is always closer to the mounting channel and the rounded edge is always outside as shown
in figure 3. Both left and right covers are opened by inserting a flat-head screwdriver in the gap located
along the mounting channel and levering up. While closing, first insert the slotted edge and squeeze-in the
rounded edge on one end and follow towards the other end.
SECTION 3:
Installation on Wall
Slotted edge Rounded edge
Figure 3