Amico Condor Adjustable Height Channel - Manual (Page 13)

MOUNTING OF ACCESSORIES
Figure 5
4. Once the accessory is at the desired height, tighten all four set screws to the tightest possible position on the
adapter using 1/8" (0.3175 cm) hex key.
5. Re-install the mounting channel stoppers onto the mounting channel by attaching them to the two holes on the
bottom of the channel ( Figure 5 ).
WARNING The channel stoppers will break if screw is over tightened.
6. Reinstall the mounting channel covers, trim off excess covers in order to fit them into the channel ( Figure 4 ).
Mounting
Channel
Mounting
Channel
Stopper
www.amico.com 13