Amico Condor Adjustable Height Channel - Manual (Page 14)

WARNING Do not over-rotate the counterbalance bolt. Once you feel resistance, stop. Forcing the bolt will
damage the internals of the Condor and void the warranty.
NOTE: Only adjust if necessary.
Adjusting the Counterbalance
1. Once the Condor is securely installed, tighten the locking knob to lock the Condor.
2. To adjust for heavier loads, slowly loosen the counterbalance bolt rotating counter-clockwise, located on the top
right corner of the Condor. To adjust for lighter loads, slowly tighten the counterbalance bolt, rotating clockwise
using a ½" (1.27 cm) socket wrench.
3. Release the locking lever. If the arm has been correctly balanced, the arm will not drop or lift and it will remain in
the same position. Ensure the arm is balanced from the lowest to the highest position by checking in various positions.
4. If arm is not correctly balanced, repeat from step 1.
Adjusting Inter-Accessory Distance
1. Once the Condor is securely installed, tighten the locking knob to lock the Condor.
2. Loosen the set screws on the adapter holding the accessory that will be moved, using an Allen Key size 1/8"
(0.3175 cm).
3. Holding the weight of the accessory, move it up and down in the channel until it reaches the desired position.
4. Tighten the set screws.
SECTION 5:
Adjustments
14 Amico Accessories Inc.