B&G H5000 Analogue Expansion - Manual (Page 13)

|
13
Planning | H5000 Installation
General
Ensure that any holes cut are in a safe position and will not weaken
the boat’s structure. If in doubt, consult a qualifi ed boat builder.
Before cutting a hole in a panel, make sure that there are no hidden
electrical wires or other parts behind the panel.
Do not mount any part where it can be used as a hand hold, where
it might be submerged, or where it will interfere with the operation,
launching or retrieving of the boat.
Leave suffi cient clearance space to connect all relevant cables.
For overall width and height requirements, please see the
dimensions section and mounting template of each device.