B&G H5000 Analogue Expansion - Manual (Page 41)

|
41
Sensor Modules | H5000 Installation
Sensor Modules
There are three types of Sensor Module, Barometer, 3D Motion
Sensor and Network Alarm.
1: Find a suitable location for the module.
Mount the module vertically. Ensure that there is at least 100 mm
clearance between the connector and grommet and any surface to
enable easy access to cables
2: Mark the hole positions, drill pilot holes and fi x into position with
two self tapping screws
 Note:
If installing a 3D Motion Sensor ensure that it is installed
vertically and facing forwards towards the bow of the boat as shown
below.
9