B&G H5000 Analogue Expansion - Manual (Page 58)

58
| Software upgrade | H5000 Installation
Software upgrade
H5000 CPU
To upgrade the CPU software to the latest version, save the .upd fi le
(upgrade fi le) to a USB memory stick. (Must be FAT or FAT32 format,
NTFS is not supported)
1 Save .upd fi le to a USB Stick. (Must be in the root folder and not a
subfolder)
2 Turn off power to the CPU
3 Remove the CPU lid
4 Insert USB stick into the USB port
5 Turn on power to the CPU
6 The CPU will automatically recognise the .upd fi le and begin the
upgrade process
7 To indicate the upgrade is in progress the USB LED on the top of the
CPU will fl ash green
8 When the USB LED turns solid green (stops fl ashing) the upgrade
process is complete
9 Remove the USB stick, the CPU will automatically reboot
 Note:
A solid red light on the USB LED indicates the upgrade was
unsuccessful. Check your .upd fi le and USB stick and repeat the
process. If you continue to experience diffi
culties updating the
software please seek assistance from a B&G specialist.