B&G H5000 Analogue Expansion - Manual (Page 59)

|
59
Software upgrade | H5000 Installation
H5000 Pilot Computer / Pilot Controller
To upgrade the H5000 Pilot Computer or controller to the latest
software version, use the Navico Software Upgrade Tool. Follow the
Navico SWUP (Software Upgrade) tool or an MFD.
Graphic Display
To upgrade the Graphic Display software to the latest version save
the .upd fi le (upgrade fi le) to a USB memory stick. (Must be FAT or
FAT32 format, NTFS is not supported)
1 Save .upd fi le to a USB Stick (Must be in the root folder and not a
subfolder)
2 Turn off power to the Graphic Display
3 Remove the service port cap on the rear of the display by unscrewing
it anti-clockwise using a suitable coin
4 Place USB stick into the USB port
5 Turn on power to the Graphic Display
6 The display will automatically recognise the .upd fi le and begin the
upgrade process
7 The display will show a message indicating the software upgrade is in
progress
8 The display will show a message once the software upgrade is
complete
9 Remove the USB stick, the Graphic Display will automatically reboot
10 Replace the service port cap