B&G Triton Display - Manual (Page 19)

| 17
Operation | Triton Operation Manual
Reset trip and time
To reset the trip and time to zero select Reset trip and time.
Alarms
If you have the relevant sensor connected to the network you can enable the corresponding
alarm by selecting it from the Alarms list.
Alarm on / off
Turn an alarm on or off from the alarm list. A tick symbol next to the alarm in the alarm list will
indicate that the alarm is on.
¼ Note: It is possible to disable all alarms by selecting Disable all alarms
Setting alarm parameters
Selecting an alarm that requires parameters to be set will take you to its alarm page. Set the
required parameter, select Enabled and select OK once complete.
The alarm can be disabled by deselecting Enabled.
Below is an example of how to set a shallow water alarm. Select Enabled and set the desired
depth.