B&G Triton Display - Manual (Page 46)

44 |
Autopilot | Triton Operation Manual
Prior to entering NoDrift mode the autopilot system should be operating in Auto, with valid
input from the GPS receiver.
Autopilot - NoDrift page
The NoDrift display presents the following information:
5
6
7
4
2
3
1
1 Response mode
2 Autopilot mode: ND = NoDrift mode
3 Compass graphic (Heading)
4 Rudder angle graphic
5 Set Heading
6 Heading
7 Set heading indicator - Green = Starboard / Red = Port
Navigation mode (Steer to waypoint)
Navigation mode requires a compatible chartplotter connected to the network for it to be an
available mode. In Navigation mode the autopilot will steer to the active waypoint.
Warning: Navigation mode must not be used while sailing, course
changes may result in unexpected tacks or gybes!
Press ‘Mode’ for approximately 3 seconds, until the Navigation mode confirmation appears on
the display.
¼ Note: When Navigation mode is selected a pop-up message will appear. You will need to
select Yes to confirm the course change before Navigation mode will be engaged.