B&G Triton Display - Manual (Page 50)

48 |
Autopilot Setup | Triton Operation Manual
Dockside
The dockside procedures are initiated from the commissioning dialog. Completed procedures
are labelled with a tick.
The following menu items are accessible and can be set up in the Installation menu:
• Boat type
• Rudder feedback
• Drive voltage
• Drive engage
• Rudder test
• Depth calibration
• Minimum wind angle
• Nav change limit
Boat Type
Type of boat selected will affect the steering parameters, and the functions available in the
autopilot system. The options are: Planing, Displacement, Sail and Outboard.
¼ Note: Wind mode is only available if boat type is set to sail.
Drive voltage (V)
Sets the drive voltage type to 12 or 24V
Rudder Feedback Calibration
Make sure the unit is installed and aligned as per instruction in the AC12/42 Installation
manual. The rudder feedback calibration will set the correct relationship between the physical
rudder movement and the rudder angle readout.
Max starboard
• Manually move the helm to starboard until the rudder stops at starboard lock hard over.
• The Max starboard angle is the angle read by the rudder feedback unit before any
adjustment is made.
• If the actual rudder angle is different from the angle displayed, correct the reading with the
Up/Down keys.
• Confirm Rudder feedback calibration to starboard by selecting Next.