B&G Triton Display - Manual (Page 20)

18 |
Operation | Triton Operation Manual
Alarm indication
The alarm system is activated if any alarm settings are exceeded.
When an alarm is notified, the alarm will be indicated with an alarm text and with an audible
alarm. There are two types of audible alarm indication. Single alarm tone or continuous alarm
tone.
¼ Note: See Alarm settings for further details on how to set an alarm.
¼ Note: If a Pilot is not on the network all Pilot alarms will be greyed out and will not be
accessible.
If the display is connected to other Network units, any alarm in the system will be displayed
on the instrument.
If no specific alarm text is displayed, an alarm code will appear.
Acknowledging an alarm
An alarm is acknowledged by pressing the ‘Enter’ key. This will remove the alarm notification
(text, light and sound) from all units that belongs to the same alarm group.
A reminder will reappear at given intervals for as long as the alarm condition exists.
¼ Note: An alarm received from other networked units must be acknowledged on the unit
generating the alarm.
Analog display alarm zones
For True Wind Speed (TWS), and deep and shallow depth alarms a red warning zone will be
visible on the analog display to give you a visual indication of alarm zones.
1 2
1 Shallow depth alarm
2 Deep water alarm