B&G Network Pilot - Manual (Page 38)

38
FAULT REPORTING
This SETUP enables the Network PILOT fault reporting to be disabled
preventing continuous alarms in the event of an intermittent rudder or
compass fault. The autopilot would not be able to steer the boat, but in
STDBY the PILOT display will still show compass heading and rudder
angles (unless there is a total system failure).
Press SETUP key until
F R ON is displayed. Press ENTER key, the
display will flash. Use the Щ Щ or Ъ Ъ keys to
select OFF or ON.
Press ENTER key to
memorise the new
F R setup.