Cooper Instruments & Systems LTL 730 Wireless Tension Link Load Cell - Manual (Page 17)

CF 150 LTL 730 14 12/08
The following screen is displayed:
Select Yes if you only want the instrument to automatically shut down when there is inactivity. Select No if you
want the instrument to power down after the timer counts down, regardless of any activity.
Config ChPwd
The next soft key is ChPwd. Use this to change the password used to access the configuration menu.
IMPORTANT: Changing the password denies access to this menu without entry of the new password.
Contact Cooper Instruments if you lose your password.
Config Reset
The last soft key in this set is the Reset soft key. Use this to reset the system to its factory default settings.
This concludes the Configuration menu section.
8.0 LTL 730 OPERATION
8.1 Display Modes
The LTL 730 has several display modes accessible by pressing the Mode soft key. See Figure 8.
The first display mode when you power up is the live force measurement mode.
Press the Mode soft key and the display changes to peak measurement mode. This mode shows the peak force
applied to the LTL 730 since the last peak clearing action. Delete the peak reading by pressing the Clear soft
key.
Press the Mode soft key again and the display shows live force and peak readings simultaneously.
Press the Mode soft key again and the display returns to the force measurement mode.
Power up display modes may be configured. See Config>Mode section.
8.2 Force Measurement
Follow these steps to perform a gross force measurement.
1. Turn on the unit with the On/Off key.
2. Remove any weight from the LTL 730.
3. Zero the LTL 730 by pressing the ZERO key.
4. Apply the force to the LTL 730 and read the gross force on the display.
You can change the units of measure of the display by pressing the Units soft key. See note below. Zero
reference is maintained after instrument power off and will be recalled with the next power-on. Zero reference
may be lost if battery power is removed.
Unit of measure can be changed only if multiple units are enabled in the Configuration menu.