Cooper Instruments & Systems LTL 730 Wireless Tension Link Load Cell - Manual (Page 21)

CF 150 LTL 730 18 12/08
Test Lets you test the following items:
Batt Press this to check the battery condition. Display shows voltage condition of the
batteries.
Disp Press this to perform a display test. Press any key to stop the test.
Keys Press this key to test individual key function. Press ESC to stop the test.
Comm Press this key to perform LOOP/NOLOOP tests onCOM1. Press ESC to return to
Test soft key display. COM1 must be enabled in Config menu to test.
Ntwrk Press this key to perform a radio test.
About Press this soft key to see the following information:
• Communicator
Serial Number
• Firmware part number
•
Revision level of software
Press ESC repeatedly to return to normal operation. If you have made changes you will be prompted to save the
changes. Press the Save soft key to save the changes and return to normal operation. Press the noSave soft
key to disregard any changes made and return to normal operation. Press the Cancel soft key to return to the
Setup menu screen.
This completes the Setup menu description.
9.3 Config Menu
The configuration menu, shown in Figure 10, allows you to set the items described below. Press the Config soft
key to enter the menu. You will be asked to key in a password, then press the Enter soft key to access the
menu.
Figure 10. Config(uration) menu
Mode Press this to set the display mode that will be active upon power-up.
Same as
LTL 730
Same as
LTL 730
Network ID
Number of LTL
730 in ntwrk
Address for LTL
730 1