Cooper Instruments & Systems LTL 730 Wireless Tension Link Load Cell - Manual (Page 26)

CF 150 LTL 730 23 12/08
Key Settings (LTL 730 2):
COM1 Trans Level – Disabled
COM2 Trans Level – RF
Radio Channel (1-64): 1 (must match Communicator setting)
Network ID (1-15): 2
Network Identifier: B
Key Settings (LTL 730 3):
COM1 Trans Level – Disabled
COM2 Trans Level – RF
Radio Channel (1-64): 1 (must match Communicator setting)
Network ID (1-15): 3
Network Identifier: C
Key Settings (LTL 730 4):
COM1 Trans Level – Disabled
COM2 Trans Level – RF
Radio Channel (1-64): 1 (must match Communicator setting)
Network ID (1-15): 4
Network Identifier: D
12.0 FCC INFORMATION
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
Agency Identification Numbers
US/FCC CAN/IC
KQL-PKLR2400 CAN2268391158A
12.1 Modifications
The FCC states that any changes or modifications to this device that are not expressly approved by Cooper
Instruments may void the user’s authority to operate the equipment.
13.0 TROUBLESHOOTING
Problem Possible Cause Solution
LTL 730 powers on
momentarily and
turns off Low battery Replace with high quality alkaline batteries
Low battery Replace with high quality alkaline batteries
Batteries installed
backwards or no
spring contact Insure that positive terminals of both batteries (nub) face inward
– towards the black cap. Check that spring is attached to the
battery cap.
Software reset Remove battery cap & reinstall after one minute. Attempt to turn
power on again.
LTL 730 does not
power on
Display contrast too
light Hold the Right Arrow key down while pressing the F2 key
several times to increase the display contrast. If nothing occurs,
release both keys. Press the power button and try again.
Display is
completely dark Display contrast too
dark Hold the Arrow key down while pressing the F1 key several
times to decrease the display contrast.
LTL 730 does not Check installation & Insure that shackles are in good working condition and aligned