Cooper Instruments & Systems WTM 502 Wire Tension Meter - Manual (Page 10)

3. Use
the Num and Adv keys to enter the Config password. Default is 0. After the number is displayed,
press the Enter key . . .
The following is displayed:
The Num keys increment and decrement the displayed numbers. The Adv key moves the
cursor to the next digit position.
Default Configuration password is 0. If a new password is lost or forgotten, contact Cooper
Instruments.
4. The unit is now in the Configuration mode. To see the rest of the softkeys available in this mode,
press the Right Arrow key. All the Config softkeys are shown below.
The softkeys in the Configuration mode are Wire, Setup, Reso, Comm, Mode, Units, Power, ChPwd,
and Reset. These are described below:
Wire Press this softkey and the wire selection screen is displayed. Choose an existing wire to
change its defining characteristics.
You have the choice of changing the Range, which is sued to set the check-tensioning
function, or the Rating, which is the maximum rating of the cable.
Range – Use this item to set the parameters for the check tensioning display. Follow the
prompts to set the following:
Lower tension limit – This is the lowest acceptable force
Upper tension limit – This is the highest acceptable force
Units – Unit of measure used in defining the tension limit
Rating – Press this softkey and you are prompted to set the ultimate rating for the cable
being used and the unit of measure for tat rating.
Setup Press the Setup softkey to view the Setup softkeys. This is the same as the Setup
softkey described in 2.31 Top Level Softkeys.
CF 142 8 V 08/09/05