Cooper Instruments & Systems WTM 502 Wire Tension Meter - Manual (Page 3)

1.0 INTRODUCTION
= Tip
= Remember
This manual covers the setup and operation of the WTM 502 Clamp Line
Tensionmeter from Cooper Instruments. The WTM 502 is a simple,
accurate strand dynamometer. It is can be clamped onto a cable, accurately
determine the wire tension and be removed in seconds.
The WTM 502 can handle multiple wire diameters, it can display live
tension, dual live/peak tension, average tension captured from several
tests, dual tension/temperature display and a check-tensioning graphical
display.
With its battery-powered electronic interface, setup and operation is made simple with on-screen prompts.
This manual covers the following:
• Unpacking
• Setup
• Operation
• Maintenance
• Troubleshooting
1.1 Unpacking
When you receive your WTM 502, unpack it and inspect the container and the instrument for any
damage. Report any problems to the shipping company immediately and save the packing materials.
Insert 2 AA batteries into the battery compartment, shown in Figure 1. Your WTM 502 probably comes
from the factory with the proper sheave size installed and calibrated for your application. If not, follow the
setup directions later in section 3.0 configuration Mode and 4.0 Changing Sheaves.
1.2 Description
The WTM 502 is shown in Figure 1 with the parts labeled.
FIGURE 1. WTM 502 PARTS
CF 142 1 V 08/09/05