Cooper Instruments & Systems WTM 502 Wire Tension Meter - Manual (Page 9)

There is a keypad shortcut for increasing and decreasing contrast. While in normal display
mode press the Arrow key and the 2
nd softkey simultaneously to increase contrast. Press the
Arrow key and first softkey simultaneously to decrease contrast.
Blite – Not currently used.
About Press this softkey to see the following information:
Device – Press this softkey to show a list of information about the WTM 502, such as – serial
number, capacity rating, hardware and software revision levels. Press any key to return to the
previous softkey set.
Calib – Press this softkey to show Calibration Points and the calibration information for the
current wire size. Follow the on-screen prompts.
O. Load – Press this softkey to show an audit count of the number of times the unit has been
overloaded beyond 125% of capacity. Press any key to return to the previous softkey set.
Zero – Press this softkey to show the deadload analysis of the WTM 502. Press any key to
return to the previous softkey set.
Ntwrk – Not used in the WTM 502.
Test Press this softkey and the following softkeys appear:
Batt – Press this softkey to test the battery level.
A-D – Press this softkey to display the A to D counts.
Disp. – Press this softkey to perform a test of the display pixels.
Keys – Press this softkey to test the keypad.
Comm – Not used in the WTM 502.
Ntwrk – Not used in the WTM 502.
Config This is a password protected menu. See section 3.0.
Press the ESC key to return to the normal operating mode. If you made changes to the
configuration of the unit you are prompted to save them or abort the changes. Do so and the unit
returns to normal operation mode.
3.0 CONFIGURATION MODE
3.1 Accessing the Configuration Mode
You need to access the Configuration mode to perform certain tasks. Access to some of these tasks may
be restricted by a supervisor password.
To access Configuration mode:
1. From a normal operating mode, press the Right Arrow softkey
A new softkey set, shown below, appears:
2. Press
the Config softkey . . .
The following is displayed:
CF 142 7 V 08/09/05