Yealink SIP-T20 - Manual (Page 85)

Basic Call Features
73
The procedures to set up a network conference call for specific servers may be different
from that introduced above. Contact your system administrator for more information.
You can use call park to place a call on hold, and then retrieve the call from another
phone in the system (for example, a phone in another office or conference room). You
can park the active call by pressing the call park key on the phone. If the call is parked
successfully, the response is either a voice prompt confirming that the call was parked,
or a visible prompt on the LCD screen.
Note
To configure a call park key via phone user interface:
1. Press .
2. Select Features->DSS Keys.
3. Select the desired DSS key.
4. Press or to select Key Event from the Type field.
5. Press or to select Call Park from the Key Type field.
6. Press or to select the desired account from the Account ID field.
7. Enter the call park code in the Value field.
8. Press to accept the change.
Call park key is configurable via web user interface at the path DSSKey->Line Key.
To use call park:
1. User on phone A places a call to phone B.
2. User on phone A wants to take the call in a conference room for privacy, then
presses the call park key on phone A.
3. User on phone A walks to an available conference room where the phone is
designated as phone C. The user dials the call park retrieve code to retrieve the
parked call.
Call park is not available on all servers. Contact your system administrator for more
information.
4. Value: *68
2aB