Media card reader – Dell OptiPlex 755 User Manual
Page 120
5.
Replace the computer cover (see
Replacing the Computer Cover
).
6.
Enter system setup (see
Entering System Setup
), and use the Diskette Drive option to enable your new floppy drive.
7.
Verify that your computer works correctly by running the Dell Diagnostics (see
Dell Diagnostics
).
Media Card Reader
Removing the Media Card Reader
1.
Follow the procedures in
Before You Begin
.
2.
Remove the computer cover (see
Removing the Computer Cover
).
3.
Remove the drive panel by sliding the drive release latch downward to open the panel, and then remove it from the hinges.
4.
Disconnect the cable from the back of the media card reader.
1
data cable
2
power cable
3
floppy drive connector (DSKT)
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before removing the computer cover.
1
media card reader
2
drive release latch