Ps/2 serial port adapter – Dell OptiPlex 755 User Manual
Page 149
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
14.
If you removed a network-adapter card connector:
a.
Enter system setup, select Integrated NIC from the Onboard Devices group, and change the setting to On (see
System Setup
).
b.
Connect the network cable to the integrated network connector on the back panel of the computer.
PS/2 Serial Port Adapter
Installing a PS/2 Serial Port Adapter
1.
Follow the procedures in
Before You Begin
.
2.
Remove the computer cover (see
Removing the Computer Cover
).
3.
Gently lift the release tab on the card retention latch from the inside and pivot the latch open.
4.
Remove the filler bracket (if applicable).
5.
Align the PS/2 serial-port adapter bracket in the retention slot and press down firmly. Ensure that the adapter is fully seated in the slot.
6.
Before you close the card retention mechanism, ensure that:
l
The tops of all cards and filler brackets are flush with the alignment bar.
l
The notch in the top of the card or filler bracket fits around the alignment guide.
7.
Secure the card(s) by closing the card retention latch and snapping it into place.
8.
Connect the adapter cable to the PS/2 serial port adapter connector (PS2/SERIAL2) on the system board (see
System Board Components
).
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
NOTE:
See the documentation that came with the adapter for information on configuring the adapter, making internal connections, or customizing it for
your computer.
NOTICE:
Do not route card cables over the cards. Cables routed over the cards can prevent the computer cover from closing properly or cause damage
to the equipment.
1 release tab
2 adapter retention latch
3 serial port adapter
bracket
4 serial port adapter
connector
5 serial port adapter system board
connector (PS2/SERIAL2)