EcoPure MW_MW30_450224 - Manual (Page 11)

11 Miracle Water Installation & Operation Manual
*VALVE DRAIN OPTIONS: Flexible drain hose is not allowed in all localities (check your plumbing
codes). For a rigid valve drain run, cut the barbed section off the drain fitting for access to the 1/4”
pipe threads. Then plumb a rigid drain as needed (see Figure 4).
Select Installation Location
Consider all of the following when selecting an installation location for the unit.
• To condition all water in the home, install the unit close to the water supply inlet, and before all other
plumbing connections, EXCEPT outside water pipes. Outside faucets should remain on hard water
to avoid wasting conditioned water and salt.
• A nearby drain is needed to carry away regeneration discharge water. Use a floor drain, laundry tub,
sump, standpipe, etc., or other options (check your local codes).
• The unit works on 24 volts only. A transformer, with a 10’ power cord attached, is included to reduce
120-60 Hz household electrical power. Provide an approved, grounded outlet within 10’ of the unit.
• Always install the unit BEFORE the water heater and after all other installed water conditioning
equipment (see Figure 5 below).