EcoPure MW_MW30_450224 - Manual (Page 16)

16 Miracle Water Installation & Operation Manual
Step 11. Connect Transformer
NOTE: Check to be sure all leadwire connectors are secure on the back of the electronic board.
CAUTION: Be sure all wiring is away from the valve gear and motor area, which rotates during
regenerations.
1. Plug the transformer into a continuously “live”, grounded house electrical outlet, approved by local
codes. THE UNIT WORKS ON 24V ONLY. DO NOT CONNECT WITHOUT THE TRANSFORMER.
Step 12. Install the Salt Hole and Faceplate Cover(s)
Complete the Programming Steps on Pages 18, 19 and 20.
Step 13. Start a Recharge
Press the (RECHARGE) button and hold for three seconds until Recharge Now begins to
flash in the timer display, starting a recharge. This recharge draws the sanitizing bleach into and
through the unit. Any air remaining in the unit is purged to the drain.
Step 14. Restart the Water Heater
Turn on the electricity or fuel supply to the water heater, and light the pilot, if applicable.
NOTE: The water heater is filled with HARD water and, as hot water is used, it refills with condi-
tioned water. In a few days, the hot water will be fully conditioned. To have fully conditioned
hot water immediately, wait until the recharge (Step 13) is over. Then, drain the water
heater until water runs cold.