EcoPure MW_MW30_450224 - Manual (Page 19)

19 Miracle Water Installation & Operation Manual
Step 4. Set Salt Efficiency
When this feature is ON, the unit will operate at salt efficiencies of 4000 grains of hardness per pound
of salt or higher. (May recharge more often using smaller salt dosage and less water).
1. Press and hold the (Select/Menu) button until the following screen is displayed.
Once in this display, press the (Select/Menu) button and one of the following two displays
is shown.
2. Press the UP or DOWN . buttons to set On or Off. When set to On, the efficiency icon will be
displayed in the upper right hand corner of the normal run display.
3. Press the (Select/Menu) button once again, to complete initial programming. RECHARGE
TONIGHT will show in the display.
If you have questions about installation, programming, operating and routine maintenance...
call 1-800-356-7851
California Efficiency Requirement
Your Miracle Water Softener has a “High Efficiency” feature with an “ON” or “OFF” setting. This
softener setting is shipped in the “OFF” position, which utilizes the maximum rated capacity while
most often achieving maximum salt efficiencies. When installing this unit in the State of California, you
MUST turn this setting to the “ON” position which may initiate more frequent recharges, however it
will operate at 4000 grains per pound of salt or higher.
If you wish to turn the Salt Efficiency feature “ON” ( icon will show in display), follow the instruc-
tions on this page.
SELECT
MENU
SELECT
MENU
SELECT
MENU